AirLive POE-5010HD - Manual (Page 29)

5. Administrating the Device
AirLive POE-5010HD User’s Manual 26
Default Gateway Enter the Default Gateway of the camera. The default
setting is 192.168.1.254
Primary/
Secondary DNS
DNS (Domain Name System) translates domain names into
IP addresses. Enter the Primary DNS and Secondary DNS
that are provided by ISP.
HTTP Port The default HTTP port is 80.
RTSP Port The default RTSP Port (Real Time Streaming Protocol) is
554.
RTP Data Port RTP (Real-time Transport Protocol) is a data transfer
protocol defined to deliver live media to the clients at the
same time, which defines the transmission of video and
audio files in real time for Internet applications. The default
RTP Data Port is 5556.
Enable Multicast: Select this option to enable the multicast function of the camera, and
then complete the following settings so that you can deliver information from your camera
to a set of receivers.
- Multicast Group Address: Assign a category of IP addresses to receive the
information from the camera.
- Multicast Video Port: Assign a multicast port for video in the text box. The default
port is 5560.
- Multicast RTCP Video Port: Assign a multicast port for RTCP (real-time transport
control protocol) video in the text box. The default port is 5561.
- Multicast Audio Port: Assign a multicast port for audio in the text box. The default
port is 5562.
- Multicast RTCP Audio Port: Assign a multicast port for RTCP (real-time transport
control protocol) audio in the text box. The default port is 5563.
- Multicast TTL: Set the value from 1 to 255. TTL (time to live) is used to specify the
time to live in the IP header so that the system is able to decide whether or not the
packet has been in the network too long and should be discarded.
Enable PPPoE: Select this option when you use a direct connection via the ADSL modem.
You should have a PPPoE account from your Internet service provider. Enter the User
Name and Password. The camera will get an IP address from the ISP as starting up.