AirLive WHA-5500CPE-NT - Manual (Page 100)

6. Command Line Interface
AirLive WHA-5500CPE-NT User’s Manual 94
„ set security <ssid> wep <key number> <64|128|152> <ascii | hex> <key
string> <defaultkey>
‰ Purpose: To set the WEP security policy
‰ Example:
Command> set security WHA-5500CPE-NT wep 1 64 hex 1234567890
Radio1 authentication type : wep !
„ set security <ssid> <wpa|wpa2> <tkip|aes|both> interval <0~300>
‰ Purpose: to set the WPA or WPA2 security policy
‰ Example:
Command> set security WHA-5500CPE-NT wpa2 tkip interval 300
Radio1 authentication type : wpa2 !
„ set security <ssid> <wpa-psk|wpa2-psk> <tkip|aes|both> interval
<0~300> <key string>
‰ Purpose: to set the WPA-PSK or WPA2-PSK security policy
‰ Example:
Command> set security WHA-5500CPE-NT wpa2-psk aes interval 300
12345678
Radio1 authentication type : wpa2-psk !
„ set ratemode <full | half | quarter>
‰ Purpose:
‰ Example:
Command> set ratemode full
Rate mode is Full(20Mhz)
„ set noise immunity <on | off>
‰ Purpose: To enable/disable the noise immunity level
‰ Example:
Command> set noise immunity on
Noise immunity is enable