AirLive WHA-5500CPE-NT - Manual (Page 47)

4. Web Management-Wireless and WAN Settings
41 AirLive WHA-5500CPE-NT User’s Manual
You can adjust the transmit output power of the WHA-5500CPE-NT’s radio from 10dBm to
24dBm. The higher the output power, the more distance WHA-5500CPE-NT can deliver.
However, it is advised that you use just enough output power so it will not create excessive
interference for the environment. Also, using too much power at close distance can create
serious performance drop due to signal distortion.
At less than 200meter distance, the best output power is about 14dBm. At 2km distance;
the best output power setting is 18dBm for “11a” and “Super-A without Turbo”, 24dBm for
“Super-A with Static/Dynamic Turbo”.
4.2.13 Advance Settings (Wireless)
Operation Mode -> Setup -> Advance Settings
This page includes all the wireless settings that change the RF behaviors of
WHA-5500CPE-NT. It is important to read through this section before attempting to make
changes.
„
Beacon Interval: Beacon Interval: The device broadcasts beacon frames regularly to
announce its existence. The beacon Interval specifies how often beacon frames are
transmitted in time unit of milliseconds. The default value is 100, and a valid value
should be between 1 and 65,535.
„
RTS Threshold: RTS/CTS frames are used to gain control of the medium for