AirLive WHA-5500CPE-NT - Manual (Page 59)

4. Web Management-Wireless and WAN Settings
53 AirLive WHA-5500CPE-NT User’s Manual
4.2.18 Bandwidth Control
Operation Mode -> Setup -> Bandwidth Control
Bandwidth Control can limit the maximum speed of entire wireless interface or individual
device. It is also known as Traffic Shaping. The WHA-5500CPE-NT provides both Total
Bandwidth and Per-User Bandwidth Control for both uplink and downlink speed. It
controls the speed of both wireless and wired interface.
To configure, please click on the “Bandwidth Control” button under wireless settings. The
following screen will appear:
„ Enable Bandwidth: Check to enable Bandwidth Control. Uncheck to disable it.
The default value is disabled.
You must select between Total Bandwidth and Per-User Bandwidth. They can not be
enabled at the same time.
„
Total Bandwidth: Total Bandwidth control limit the bandwidth between Wireless and
Ethernet interface. Therefore, it is most suitable for Client Infrastructure Mode, Bridge
Mode, and WISP Router Mode. For WISP operator who use WHA-5500CPE-NT as
the client side device; setting the Total Bandwidth control on the WHA-5500CPE-NT
After enabling
Bandwidth Control
and selecting
“Total” or “Per
User” type, click
here to Apply
Check to enable
Bandwidth
Control
Select Total or
Per User
control here
Settings for
Total Bandwidth
Control
Settings for
Per-User Bandwidth
Control