3 show commands – AirLive WHA-5500CPE-NT User Manual
Page 89
6. Command Line Interface
83
AirLive WHA-5500CPE-NT User’s Manual
Example:
Command> z_debug add ssid air1
z_debug reboot
Purpose: reboot your WHA-5500CPE-NT
Example:
Command> z_debug reboot
Rebooting...
z_debug set port radio1 11a <ssid> <channel>
Purpose: Set SSID and Channel. We recommend using set commands
instead;
set ssid <ssid> : to set the ssid name
set rate mode <mode value>: set radio mode to 11a | supera_no_turbo
| supera_static_turbo.| supera_dynamic_turbo
Example:
Command> z_debug set port radio1 11a air2 64
6.3 Show Commands
Show Commands are command that show the settings and status of WHA-5500CPE-NT
show arp table
Purpose: Show ARP Table
Example:
Command> show arp table
IP address Flags HWaddress Device
--------------------------------------------------------------------------------------------
192.168.1.100 C 00:1D:60:5E:AE:A0 lan
show http
Purpose: Show HTTP service settings
Example:
Command> show http
HTTP service port: 80
HTTP session timeout: 10 minutes