Garland MO QU 28000 FL INDUCTION MODULE-LINE COOKTOPS DUAL/QUAD - Manual (Page 28)

Installation RTCSmp Built-In Module-Line Dual/Quad Cooktops
28 Part # 4532415 Rev 3 (8/19/14)
4.5.6 Custom-Built Mounting Frame
Mounting Frame for countertop thickness of 1.5mm to 3mm / 16- to 10-gauge (Typ.): See section 4.5.4.
Mounting Frame for countertop thickness of 20-30mm/ 1”:
For an application with countertop thickness about 1” or 20 – 30 mm, a custom-built mounting frame is
required to flush-mount the glasstop and install the coil carrier sheet properly. When designing an
appropriate frame, use the design criteria and the example below as your guide.
NOTE: You may re-use existing parts from the mounting frame provided.
NOTE: Refer to section 4.5.4 and 4.5.5 for cut-out dimensions and recommended installation procedure.
NOTE: Please contact Garland if you would require assistance on designing a proper frame. CAD files for
the example shown in this section are available upon request.
Mounting Frame Design Criteria
 The coil carrier sheet(s) should be easily removable for service/maintenance without taking out the glass-
top.
 Height-adjustable feature for leveling the unit during installation is desirable.
 Use 10- to 14-gauge metal (typ. 12-gauge) for the mounting frame.
 When installing two coil carrier sheets on the same frame, you must install a non-magnetic steel
partition plate in between them. This will isolate the magnetic fields and prevent the fields from
interfering each other.
 The mounting frame has to support the total weight of the glass, the coil carrier sheet(s), the cookware,
and food product.
 Critical dimensions:
o Countertop cut-out dimension, see section 4.5.4.
o Distance from the underside of the coil carrier sheet to the Ceran glass after installation: 50mm
+/- 2mm.
o Thickness of glass + silicone gasket + silicone seal = 6mm + 3mm + approx. 0.5mm = total
approx. 9.5mm. See section 4.5.5 steps C to F.