Garland MO QU 28000 FL INDUCTION MODULE-LINE COOKTOPS DUAL/QUAD - Manual (Page 36)

Installation RTCSmp Built-In Module-Line Dual/Quad Cooktops
36 Part # 4532415 Rev 3 (8/19/14)
To setup the unit for operation:
1. Ensure the control knobs are at the OFF-Position.
ON-Position
Any position where
“0” is not pointing to
the LED light. The
light is on. OFF-Position
“0” points to the LED
light. The light is off.
2. Remove all objects from the glass-tops.
3. Review the components and cable connections charts in section 4.6 Models, Components and Cable
Connections.
IMPORTANT:
 Always connect the cables according to the labels affixed next to the connectors and on
the cables.
 The cables—coils, sensors, CAN/BUS, mains— must be connected correctly.
 Ensure the insertion tongues of the RJ-45 cable (CAN/BUS) are fully engaged.
 The coil and sensor cables must be routed separately and MUST NOT rest on one
another.
 The sensor and RJ45 cables must be routed separately and MUST NOT rest on one
another.
 Ensure ALL coil/sensor connectors are connected correctly before turning on the
unit.
4. Connect the unit to the power supply.
5. Perform the Function Test. See chapter 5 Function Test.