Garland MO QU 28000 FL INDUCTION MODULE-LINE COOKTOPS DUAL/QUAD - Manual (Page 41)

Operating Instructions RTCSmp Built-In Module-Line Dual/Quad Cooktops
Part # 4532415 Rev 3 (8/19/14) Page 41
6.4 No Pan No Heat
When a temperature is chosen, the induction unit only transmits energy when a pan is placed in the heating zone.
If you remove the pan from the heating zone, power transfer to the pan stops immediately. If the pan is put back
in the heating zone, power is transferred to the pan again.
Note the signals given by the green indicator light:
 The green indicator light flashes when the unit is ON but without any pan placed on the hob; the unit is
in pan detection mode.
 As soon as a pan is put on the hob, the heating process is engaged and the indicator light stops flashing
and remains bright. However, the indicator light will keep flashing if the unit is unable to detect any pan
or an unsuitable pan is placed on the glass-top.
After switching the unit off, there is no heat retained inside the unit.
NOTE: Pan with a bottom diameter smaller than 5”(12 cm) is not detected by the system.
6.5 When Unit is Not In Use
Best Practice: If the induction unit is not in use, ensure the control knob is in the 0 (OFF) position.
 Switch the unit OFF if you take the cookware away for a while. This will prevent the heating process to
start automatically and unintentionally when a pan is placed back on the heating area. If any person
needs to use the induction unit, he/she will have to turn the unit ON intentionally.