HYDAC CMU 1000 - Manual (Page 24)

Condition Monitoring Unit CMU 1000 Page 24
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
Level 1 Level 2 Level 3 Level 4 Level 5 Level 6
High
range [Enter
value]
Decimal
format
0
0.0
0.00
0.00
Channel I
:
Channel P
Unit (of
measurement) [Enter
unit]
Name
[Enter
name]
Mode
Off
Active
High
range [Enter
value]
Factor
[Enter
value]
Decimal
format
0
0.0
0.00
0.00
Channel settings
Channel Q
:
Channel R
Unit (of
measurement) [Enter
unit]
PWM 1
(analog output 1)
0 to 20 mA
4 to 20 mA
0 to 10 V
Settings Peripherals
PWM settings
(analog outputs)
PWM 2
(analog output 2)
0 to 20 mA
4 to 20 mA
0 to 10 V
5.1.2 Key Functions during Operation on the Device
The setting parameters and displays listed in the previously shown menu structure can
be called up and the corresponding settings and selections can be made with the key
pad.
Pressing the o.k. key once takes you out of the measured value display and
into the CMU 1000 menu. .
You can switch between the individual menu options of a level by pressing the
keys ▲ or ▼ .
The next-lower menu level can be accessed by pressing the o.k. key once.
You can go back to the next-higher menu level by pressing the Esc key once.
The selection of the specific setting values (e.g. interface, date format, mode,...)
can be made with the ▲ ▼ keys and confirmed by pressing the o.k. key.
To enter name, date and time values, addresses measurement ranges, etc.,
select the cursor position with the ◄ ► keys.
Use the ▲ ▼ keys to select the required uppercase and lowercase letters,
numbers and special characters.
Press the o.k. key to confirm the completed entry.
Pressing the Esc key aborts the entry without applying the changes.