HYDAC CMU 1000 - Manual (Page 49)

Condition Monitoring Unit CMU 1000 Page 49
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
5.2.5.2 Display Device Information
• Here the values of the following status parameters are displayed:
- Part numer
- Serial number
- Channel information
The Channel information reflects the numerical input values from the CM
Program. Channel 0 corresponds thereby to the first numerical input value in
the CM Program, Channel 1 the second one, etc.
If no CM Program is available in the device, then the connected sensors will be
displayed in this position with measurement range and unit.
5.2.5.3 Sensor Values
• Here the result values (Numerical output values) from the CM Program in the
device are displayed.
If no CM Program is available in the device, then the measured values of the
connected sensors will be displayed.
920112
PT 0011
920112
PT 0011