HYDAC CMU 1000 - Manual (Page 31)

Condition Monitoring Unit CMU 1000 Page 31
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
• Select Change in the Bus address line. The following window opens:
• Select the respective device address in the selection window (Address d in our
example).
• Confirm this with OK.
• Afterwards click on Connect to connect the PC to the CMU 1000 (Address d).
• The successful establishment of the connection will be signalled as shown
below:
• End the connection setup by confirming with OK.