HYDAC CMU 1000 - Manual (Page 64)

Condition Monitoring Unit CMU 1000 Page 64
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
5.2.6.2 Set Password Protection
• To prevent unauthorized access to the CMU 1000, you can equip the device
with password protection. Select the function Set password protection for this
purpose. The following window opens:
You are prompted at this point to enter a password. If the CMU 1000 is still in
the condition it was at the time of delivery or if no password protection has been
set, then the standard password for this function is:
0000 .
Afterwards, disconnect the link to the CMU 1000 and then reconnect it. The
following window opens:
- Enter the Password and then click on OK in order to have unlimited access to
the CMU 1000.
- If you click on Cancel without entering a password, then you will obtain only
"Reading Rights". You can only access the following information:
Sensor status, sensor information, measured values, input values
The CM Manager is reduced in such cases to the following functions:
It was not possible to carry out any settings.