HYDAC CMU 1000 - Manual (Page 65)

Condition Monitoring Unit CMU 1000 Page 65
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
5.2.6.3 Change Password
• Here you have the opportunity of changing the password. After the Change
passwort function has been selected, the following window opens:
- Enter the previous password in the top line.
- Enter the new password in the middle line.
- Repeat the new password in the bottom line.
- Confirm the action with OK (the new password is immediately activated) or
end the action by clicking on Cancel without changing the password.
5.2.6.4 Removing Password Protection
• To remove the password protection in the device again, select the function
Remove password protection
. The following window opens:
- Enter the currently valid password.
- Confirm the action with OK (password protection is immediately deactivated)
or end the action by clicking on Cancel without deactivating the password
protection.
5.2.6.5 Send Commands
• With this menu option it will be possible with future device versions to send
direct commands to the CMU 1000 in order to initiate certain functions there.
This menu option has no function at present.