HYDAC CMU 1000 - Manual (Page 75)

Condition Monitoring Unit CMU 1000 Page 75
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
6.1.6 Sensor Configuration
Sensor configuration
is understood to mean all of the input-relevant settings in the
CMU 1000 (Peripherals settings). The sensor configuration can only be generated with
the CMU 1000 itself (offline generation in CMWIN is not possible). All necessary
sensors must be connected in order for this to be possible.
A sensor configuration can be saved in files and loaded from files, and can be both
received and transferred by the CMU 1000.
The configuration files have the extension *.hedcf.
The sensor configuration contains the following data:
- Sensor name
- Mode
- Measurement range
- Decimals
- Units of the individual measured values
A status message at the lower edge of the window of the CM Editor indicates whether
or not a sensor configuration is available.
• With the function Apply from file, you can open a saved sensor configuration
file and use it in the CM Editor.
To accomplish this, enter the corresponding path and file name in the window
that opens and then click on Open.
• With the function Apply from device, you transfer one of the sensor
configuration
stored in the CMU 1000 to your PC, after which you can use it in the CM Editor.
• With Uninstall you delete the currently available sensor constellation in the CM
Editor, after which it is no longer available for further use when generating
programs.
No saved constellation files are deleted!
• To save a configuration file, select Saving to a file. Enter the respective path
and desired file name for this purpose in the window that opens.