HYDAC CMU 1000 - Manual (Page 56)

Condition Monitoring Unit CMU 1000 Page 56
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
- With Load you can transfer a configuration file (marked in the lower display field)
from the PC to the CMU 1000. The following message appears after the
completion of the transfer:
All of the settings stored in the configuration file were carried out after the transfer
of the file in the CMU 1000.
- When you press Save, you generate a new configuration file or save a modified
one to the previously specified target folder (in our example: C:\Temp). The
following window opens for this purpose:
- Pressing Delete causes the configuration file in the target folder marked in the
lower display field to be deleted.
- Pressing Refresh causes the display field for the configuration files to be
updated. The defined target folder will be read out again for this purpose.
This is necessary, e.g. when you copy or delete configuration files with Windows
Explorer. These changes will not be displayed in the folder until after "Refresh"
has been carried out in CMWIN.
- With Display you can display the respective momentary "Actual Configuration" of
the connected CMU 1000.
The individual configuration files are explained briefly in the following:
File save as
Save in:
File name:
File type:
Save
Cancel