HYDAC CMU 1000 - Manual (Page 72)

Condition Monitoring Unit CMU 1000 Page 72
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
6.1.3 Grouping
• With Create grouping you can join several functions to make an
interconnected unit and transfer and copy these as a block.
First mark the functions to be grouped by enclosing them in a frame created
with the help of the cursor.
Afterwards, select “Group“ in the menu bar and then “Create grouping“ in the
drop-down menu that appears.
• Pressing “Cancel grouping“ releases the functions linked together in the group
from one another again.
To accomplish this, mark the desired group with a mouse click on any one of
the functions within the group.
Afterwards, select “Group“ in the menu bar and then “Cancel grouping“ in
the drop-down menu that appears.
6.1.4 Device
The "Connection“ function can be used to set up a connection between the PC and a
CMU 1000 from the CM Editor.
The function is identical with the connection setup in the CM Manager. See in this
connection Chap. 5.2.1. ff.