HYDAC CMU 1000 - Manual (Page 46)

Condition Monitoring Unit CMU 1000 Page 46
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
• Enter the IP Address stored in the network settings of the CMU 1000.
• You can set up a list of addresses (address book) with Address list.
• With Connection test you can test the link from the PC to the CMU 1000. If the
IP Address has been entered correctly, then the following message will appear:
• Click on “OK“ to apply the entries or “Cancel“ to discard these changes. In
either case you will then return to the Connection window.
• Click on Open to open the selected interface. The opened interface is indicated
by a green dot on the upper right.
• Afterwards click on Connect to connect the PC to the CMU
• The successful establishment of the connection will be signalled as shown
below: