Kinze ISOBUS Electronics Package (4900) Rev. 4/14 - Manual (Page 22)

M0250 ISOBUS
18 Rev. 4/14
TM
PRESCRIPTION POPULATION
Prescription rates come from the Task Controller which is commonly located inside the Virtual Terminal in the cab.
Prescription maps must be created in farm management software and loaded into the display prior to planting.
Rates supplied by the Task Controller will be displayed on the prescription screen. You must be on the prescription
screen to use the prescription rate.
The data boxes below the tractor and planter graphic show the set population for your current location. Prescription
rates will only be used if prescription is selected in this screen.
PRIME AND FLUSh
1. Select Prime or Flush to prime or flush meters.
2. Prime will turn the meters one and a quarter
revolution to load seed in disk. Flush will turn at a
set rate until Stop button is pushed.
3. If process is not ready to be performed, select
Back.
Planting Setup
Press START to run all seed meters.
They will operate until STOP is pressed.
SEED METER FLUSh
BACK STOP
START