Set fertilizer screens, Prime and flush, Set fertilizer screens prime and flush – Kinze ISOBUS Electronics Package (4900) Rev. 4/14 User Manual
Page 26: Fertilizer flush, Back stop start
SET FERTILIZER SCREENS
1 of 4
1. Select fertilizer option
GALLONS / ACRE
2. Turn ON/OFF fertilizer when rows are on and planting
First, select fertilizer option: Basic or Prescription.
Select desired rate of gallons per acre.
Prescription rates come from the Task Controller which is commonly located inside the Virtual Terminal in the cab.
Prescription maps must be created in farm management software and loaded into the display prior to planting.
Rates supplied by the Task Controller will be displayed on the prescription screen. You must be on the prescription
screen to use the prescription rate.
The data boxes below the tractor and planter graphic show the set rate for your current location. Prescription rates will
only be used if prescription is selected in this screen.
PRIME AND FLUSh
Select Prime or Flush to prime or flush pump.
Prime will turn the pump on for 10 seconds to fill
lines with liquid. Flush will turn pump until Stop
button is pushed.
If process is not ready to be performed, select
Press START to run pump.
It will operate until STOP is pressed.