Landoll 2211 Ripoll - Manual (Page 31)

ASSEMBLY INSTRUCTIONS
3-15
Disc Gang and Depth
Adjustment Installation

DANGER
1. Assemble the disc gang lift to the frame. Install the 4"
UHMW bearings and bearing caps using 3/4-10 x 2
hex head cap screws and hex lock nuts (See
Figures 3-8 and 3-9.)
2. Install 4 x 8 hydraulic cylinder with rod pointing up to
the frame weldment using the clevis pins and roll
pins which come with each cylinder.
3. Install 2- 90
o
elbow w/ restrictor into the butt end of
the cylinder.
NOTE
Assemble front gangs first to prevent machine from
tipping over backwards.
IMPORTANT
For proper operation, the 90
o
elbows w/ restrictors
must be the same in each end of the 4 x 8 hydraulic
cylinder.
Figure 3-10: Top View of Radius Rod Installation - 2211-13 & -15
Disc blades are extremely sharp. Exercise
extreme care when working on or near disc
blades. Do not allow disc to roll over or fall onto
any body part. Do not allow wrenches to slip
when working near disc blades. Never push
wrenches toward disc blades. Do not climb over
machine above disc blades. Failure to stay clear
of disc blade edges can cause serious personal
injury or death.
REAR GANGS
4-1/2” SPACER
1-3/4” SPACER
DOUBLER PLATE
FRONT GANGS
1-8 X 12 HEX HEAD
CAP SCREW
2211-13-15 radius rod inst