Landoll 2211 Ripoll - Manual (Page 76)

5-2 F-571-0613 Edition
TROUBLESHOOTING GUIDE
DISC GANG PLUGGING Operating depth too deep Raise unit.
Conditions too wet Wait until conditions more favorable.
DISC GANG WILL NOT TURN OR
PUSHES SOIL Depth set too deep for loose or wet
conditions Raise implement or wait until conditions
are more favorable.
Gang bearing failure Replace bearing
DISC BLADES LOOSE AND/OR
SHEARING ROLL PIN Gang not tightened properly Retighten gang shafts to 1200-1500 ft-lbs.
If gangs have ran loose, gangs may
require disassembly to remove soil to
properly torque gang shafts. Replace
any worn components, shafts/spools,
etc.
WINGS FLOATING/BOUNCING IN FIELD Wing latch not hooked Fully extended fold cylinder and be sure
3/4-10 x 3 hex head cap screw in the
top of the hook is free to rotate. .
PROBLEM PROBABLE CAUSE SOLUTION