Figure 3-11: front disc gang installation, Figure 3-12: roll pin installation – Landoll 2211 Ripoll User Manual
Page 32
3-16
F-571-0613 Edition
ASSEMBLY INSTRUCTIONS
4.
Lift front gangs up under frame and install 1-7/16 x
6-3/8" pin on inner mount with roll pins (See
Figure 3-11.)
5.
Attach pivot block and orientate as shown so the
flanges are to the top and bottom. Slide gang from
the rear of the outer gang mounts into the front
position.
6.
Install the bushing and 1-8 x 6 hex head cap screw
and hex lock nut at the rear of the gang mount to
secure the gang assembly.
IMPORTANT
Make sure the hex lock nut is located on top of the
gang assembly.
7.
Install roll pins into the pin, disc angle. The 4" roll pin
will just go through the pin to act as a handle. The 2"
roll pin will be centered in the pin (See Figure 3-12.)
Figure 3-11: Front Disc Gang Installation
Figure 3-12: Roll Pin Installation
3/8 x 4 ROLL
PIN
3/8 X 2 ROLL
PIN
1/4 HAIR PIN
BUSHING
1-8 X 6 HEX
HEAD CAP
SCREW
1” DISC ANGLE PIN
1-7/16 X 6-3/8
PIN
3/8 X 2-1/2
ROLL PIN
NOTE:
PIVOT BLOCK
ORIENTATION
1-8 HEX
LOCK NUT
2211 frt gang
3/8 x 4 ROLL
PIN
3/8 X 2 ROLL
PIN
1” DISC ANGLE PIN
roll pin installation