Landoll 2211 Ripoll - Manual (Page 61)

OPERATION AND MAINTENANCE
4-5
5. To fold/unfold the Ripoll, find a level area large
enough to accommodate the Ripoll when it is fully
unfolded. The tractor should be stopped and not
moving with the unit fully raised (See Figures 4-5
and 4-6.)
IMPORTANT
Failure to remove the lock pins when unfolding will
result in serious damage to the implement. Be sure
other people and pets are a safe distance away.
6. Slowly engage the tractor lever and fold/unfold the
wing frames. When the wings are unfolded, continue
holding the tractor lever to fully extend both fold
cylinders. This will allow the wing latches to fully
engage creating a rigid wing for field operation.
7. When the unit is fully folded, rotate pins as shown
and push forward to engage the wing lock pin, and
then rotate the opposite direction to lock the pins in
place.
8. Before unfolding the unit, rotate pins and pull
rearward to disengage the wing lock pin, and then
rotate the opposite direction to lock the pins in place
for storage.

WARNING
Figure 4-5: Position in Folded Position
Figure 4-6: Position in Unfolded Position
Unfold wings before doing any type of service or
repair to the fold cylinders or hydraulic lines
supplying oil to the fold cylinders. The wings will
naturally unfold if the oil pressure is relieved,
thus allowing wings to fall to the ground.
FOLD LOCK
WING LOCK PIN
2211-15-fold-lock
FOLD LOCK
WING LOCK PIN
2211-15-unfold-lock