Landoll 2211 Ripoll - Manual (Page 47)

ASSEMBLY INSTRUCTIONS
3-31
Rear Jack Installation
A rear jack assembly is used on the rear of the 2211-13 &
-15 Ripoll models and is an option on the 2211-09 & -11
models. This is extremely helpful if an attachment has
been added to the rear of the machine for stability.
1. Attach rear jack mount and rear jack plate to the rear
frame of the Ripoll using 3/4-10 x 4 hex head cap
screws and hex lock nuts (See Figure 3-27.)
IMPORTANT
The rear jack tube should be located to the rear of the
Ripoll near the center of the frame.
2. Slide rear jack square tube into rear jack mount from
the bottom and hold in desired location with wing lock
pin, 1/4 x 3 slotted roll pin, and 3/16 hair pin.
3. Attach jack mount tube to rear jack square tube using
3/4-10 x 4 hex head cap screw and hex lock nut.
Figure 3-27: Rear Jack Installation
3/4-10 X 4 HEX HEAD
CAP SCREW
3/4W FLAT WASHER
REAR JACK MOUNT
3/16 HAIR PIN
3/4-10 HEX LOCK NUT
REAR JACK
SQUARE TUBE
3/4-10 X 4 HEX HEAD
CAP SCREW
WING LOCK
PIN
REAR JACK PLATE
JACK MOUNT
TUBE
1/4 X 3 SLOTTED
ROLL PIN
3/4-10 HEX
LOCK NUT
m160600 op