Landoll 2211 Ripoll - Manual (Page 63)

OPERATION AND MAINTENANCE
4-7
Field Operation
1. Raise the unit to take the weight off of the transport
locks. Remove the transport locks from the lift
cylinders. Store the transport locks on the retainers
above the main lift (See Figure 4-7.)
Figure 4-7: Stored Transport Locks
Leveling (Front-to-Rear)
1. The leveling feature on the Ripoll is used to keep the
machine level when raising the unit from a working
position to a transport position. The leveling feature
is also used to level the unit from front-to-rear to
perform a level operation in the field.
2. The unit should be level from front to rear. This will
reduce horsepower requirements, allow a more
uniform tillage operation, and reduce unnecessary
point wear.
3. To adjust the leveling feature, loosen jam nuts at
each end of the radius rod using the adjustment
wrenches provided on the hitch (See Figure 4-8.) To
raise the front of the Ripoll, lengthen the radius rod
assembly. To lower the front of the Ripoll, shorten the
radius rod assembly. After adjusting, retighten jam
nuts at each end. Adjustments should be made in
small increments.
Figure 4-8: Radius Rod Leveling Adjustment
stored trans lock
1-1/2 X 16 LOCKOUT
CYLINDER STOP
L-PIN
1/8 HAIRPIN
2211 level
HITCH RADIUS
ROD ASSEMBLY
ADJUSTMENT
WRENCHES
1-1/2 - 6 HEX
JAM NUTS