Landoll 2211 Ripoll - Manual (Page 41)

ASSEMBLY INSTRUCTIONS
3-25
Figure 3-22: Hitch Hose Clamps and Color Designation
Hydraulic Installation
NOTE
Refer to Figures 3-18 through 3-21 for wheel lift, disc
gang lift, and wing fold hydraulic diagrams. See Figure
3-23 for routing of hydraulic hoses on 2211-09 and -11
models.
1. Install the manifold(s) to the manifold bracket on the
frame using 1/2-13 x 3-1/2 hex head cap screws and
hex lock nuts.
2. Install fittings into manifolds according to Figures
3-18 through 3-21.
3. Install wheel lift and disc gang lift system hoses per
Figures 3-18, 3-19, and 3-20.
4. Install wing fold system hoses (2211-13 and -15
models) per Figure 3-21.
5. Hold each system of hoses in place using 3/8-16 x 3
(2211-09 and -11 models) or 3/8-16 x 4 (2211-13 and
-15 models) hex head cap screw, hose clamps, and
hex lock nut (See Figure 3-22.)
6. Install steel plugs in any remaining open manifold or
valve ports.
7. Install hose wraps around system hoses per hose
identification decal near hose couplers, putting both
hoses inside wrap (See Figure 3-22.) Note that no
yellow hose wrap is used on rigid models.
Figure 3-23: 2211-09 and -11 Hydraulic Hose Routing
3/8-16 X 3 OR
3/8-16 X 4 HEX
HEAD CAP SCREW
HOSE CLAMPS
3/8-16 HEX LOCK NUT
2210 hitch hose clamps
DISC GANG LIFT
HOSES TO
TRACTOR
RUN HOSES THROUGH
LIFT BEARING MOUNTS
NOTE: RADIUS ROD
REMOVED FOR CLARITY
hyd hose routing