Landoll 2211 Ripoll - Manual (Page 75)

5-1
Chapter 5
Troubleshooting Guide
The Troubleshooting Guide, shown below, is included to
help you quickly locate problems that can happen using
your 2211 Ripoll. Follow all safety precautions stated in
the previous sections when making any adjustments to
your machine.
PROBLEM PROBABLE CAUSE SOLUTION
UNIT NOT PULLING EVEN Disc gangs uneven depth Adjust depth/rephase disc gang
cylinders (See “Hydraulic Disc
Gang Lift System” on page 4-6.)
UNEVEN DEPTH Unit not level when under power in the
field Level unit front to rear (See “Leveling
(Front-to-Rear)” on page 4-7.)
Excessive disc gang depth or down
pressure Reduce disc depth.
Tire pressure too low Check inflation.
Unit not level front to rear Adjust unit to be level.
UNIT SIDE DRAFTS OR MOVES SIDE
TO SIDE Lift wheels not carrying enough weight Adjust depth stop and raise implement.
Unit not level front to rear Adjust unit to be level.
SHANKS PLUGGING WITH RESIDUE Unit not level Level machine (See “Leveling
(Front-to-Rear)” on page 4-7.)
Discs not cutting residue Adjust disc depth or raise shanks to allow
more gang depth.
SHANKS NOT PENETRATING Unit not level Level unit front to rear (See “Leveling
(Front-to-Rear)” on page 4-7.)
Excessive disc depth Reduce depth
Points worn Install new points.
WHEEL BEARING FAILURE Triple-lip seals not installed correctly Install seals with the lips pointing outward
away from the hub.
HYDRAULIC - DISC GANG LIFT
CYLINDER NOT FULLY EXTENDING Hoses not properly connected Check hose routing
HYDRAULIC - ENTIRE UNIT SETTLING Depth stop valve not working Repair valve