Landoll 2211 Ripoll - Manual (Page 45)

ASSEMBLY INSTRUCTIONS
3-29
Light Installation (After August,
2013)
NOTE
See Figures 2-1 through 2-4 for light bracket
placement. If no dimension is given for a bracket, it
should be located against frame member as shown in
drawing.
1. Attach inner tail light mounting bracket supports to
the center frames using u-bolts and hex lock nuts
(See Figure 3-24.)
2. Attach outer LH and RH light brackets to frame
weldment using 1/2-13 x 9-1/2 hex head cap screws
and hex lock nuts.
3. Attach ag red single LED brake lamps to inner tail
light mounting bracket and ag amber single LED
lamps to outer light brackets using 1/4-20 x 1-1/4 hex
head cap screws and hex lock nuts.
4. Mount ag flasher control module on right hand tail
light bracket using 1/4-20 x 1-1/2 hex head cap
screws and nuts. Connect rear harness to module
and connect the right/left side lights accordingly.
Route main wire harness through hose holder on
hitch, down the right side of the center frame and
across the back to the enhanced lighting module
plug.
5. Connect warning light harnesses to lights. Note that
1-24" harness extensions is required at the rear of
the main harness for adequate length.
6. Attach SMV emblem and mounting bracket to rear
center frame bar using u-bolt, 1/4-20 x 1 hex head
cap screws, and hex lock nuts. The SMV sign should
be centered on the rear bar of the frame.