Leica Biosystems EG1150 H - Manual (Page 28)

28 Instructions for Use V 2.5 RevF – 09/2014
5. Operation
5.5 Time-program control
The value shown in the display must be set to the current local time to
ensure the correct operation of the time-program control.
Setting the time
• Press the CLOCK button as many times as required until the green "TIME"
LED lights up.
• Set the current time with the / buttons.
The required value is reached faster when holding down the button in
question.
Start time
The start time is the time at which the instrument automatically switches
from standby to operating mode.
Setting the start-of-work and end-of-work times:
• Press the CLOCK button as many times as required until the green LED
"START" lights up.
• Set the start time with the / buttons.
The required value is reached faster when holding down the button in
question.
End time
Automatic switch-over of the unit from operating to standby mode takes
place at the set ending time.
Setting the start-of-work and end-of-work times:
• Press the CLOCK button as many times as required until the green "END"
LED lights up. Set the time as described above.
Fig. 19
All the set times are stored until they are changed, even if the instru-
ment is switched off with the standby switch.