Leica Biosystems ANGLE TWO - Manual (Page 21)

Components
Leica Angle Two ™ User Manual Rev A02 © Leica Biosystems Richmond Inc. 2010 21
Figure 20. The probe shaft screw
Attaching a Probe
At the bottom of the standard probe shaft is a plastic block with three grooved faces and one flat
face. Insert the probe into one of the grooves (grooves are 1 mm apart) and tighten the metal
clamp to secure.
Figure 21. The probe holder at the bottom of the probe shaft
Probe clamp
screw
Grooves on the
plastic block
Clamp screw
Metal clamp
Probe shaft