Software overview – Leica Biosystems ANGLE TWO User Manual
Page 24
Leica Angle Two
™
User Manual Rev A02 © Leica Biosystems Richmond Inc. 2010
24
4
Software Overview
This chapter describes the Angle Two
™
software and its functions.
The topics covered are:
“Atlas” on page 25 – how to select an atlas and view the coronal plates.
“Modes” on page 26 – explains what Set Target, To Target, Atlas and Vertical are used for.
“Initial Settings” on page 29 – describes how to set the tilt direction, zero the rotation and tilt angles, enter
offsets and indicate bregma and lambda to the software.
“Coordinates” on page 31 – how to save and export coordinates, and how to use saved coordinates.
Figure 23 shows the software interface, with the atlas coronal plate in the center and the right and left
manipulator controls on either side. Clicking anywhere on the left or right side of the screen activates the
respective manipulator’s controls for use. If you have only one manipulator, then only one side of the screen will
be active.
Figure 23. The Angle Two screen with the left manipulator attached