Leica Biosystems ANGLE TWO - Manual (Page 26)

Software Overview
Leica Angle Two ™ User Manual Rev A02 © Leica Biosystems Richmond Inc. 2010 26
4.2 Modes
Four modes are used during surgery: Set Target, To Target, Atlas and Vertical. Each mode is
used for a specific function and has its own set of coordinate boxes that appear beneath the mode
selection area. Click the appropriate mode to activate it for use.
Figure 25. The four modes and coordinate boxes
Set Target
Select Set Target mode to enter the position of the target site – where the probe will go.
The target site appears as a red crosshair on the coronal plate and its ML, AP and DV coordinates
are displayed in the Target (Red) coordinate boxes (see Figure 25).
Target coordinates can be edited at any time and saved. To save target coordinates click Save
Named Point (see “Saving” on page 31).
There are three ways to enter the coordinates:
1. Select the coronal plate showing the target site and click on a position in the map to set it as
the target.
2. Use saved coordinates – double click on saved coordinates located across the bottom of the
screen. The coordinates are automatically entered and a red crosshair appears (see Figure 26).
Coordinate
boxes for the
selected mode
Modes