Lenze SMD 0-25kW-4-0kW - Manual (Page 6)

4 Lenze 13435747 EDBSX03 v17 EN, DE, FR, IT, ES
Safety information
Operation
Systems including controllers must be equipped with additional monitoring and protection devices
according to the corresponding standards (e.g. technical equipment, regulations for prevention
of accidents, etc.). You are allowed to adapt the controller to your application as described in the
documentation.
DANGER!
• After the controller has been disconnected from the supply voltage, live components
and power connection must not be touched immediately, since capacitors could be
charged. Please observe the corresponding notes on the controller.
• Do not continuously cycle input power to the controller more than once every 3 minutes.
• Please close all protective covers and doors during operation.
1.1 Pictographs used in these instructions
Pictograph Signal word Meaning Consequences if ignored
DANGER! Warning of Hazardous
Electrical Voltage
Reference to an imminent danger that may
result in death or serious personal injury if
the corresponding measures are not taken.
WARNING! Impending or possible
danger for persons
Death or injury
STOP! Possible damage to
equipment
Damage to drive system or its surroundings
NOTE Useful tip If observed, it will make using the drive
easier