Lenze PMSS1000 Simple Servo - Manual (Page 57)

Indexer-Programmer-Manual.pdf REV 1.3
Example:
EVENT Event1 IN_A1 RAISE ; switch event
JUMP
EventCodeProcess
ENDEVENT
EVENT Event2 IN_A1 RAISE ; switch event
JUMP
EventCodeProcess
ENDEVENT
EVENT Event1 ON
EVENT Event2 ON
{
User
code
}
EVENTS OFF
;all events are disabled
.
.
EVENTS ON
;Events Event1 and Event2 enabled again
FAULT User generate fault Statement
Purpose
Allows user program set custom system fault. This is useful when custom program needs
to standard fault process for custom conditions like data supplied by interface out of
range etc. Custom fault numbers must be in region of 128 to 240 (decimal)
Syntax
FAULT FaultNumber Sets system fault.
Faultnumber – constant in range 128-240
Variables are not allowed in this statement.
Remarks
Custom fault will be processed as any regular fault. There will be a record in the fault log.
See Also ON FAULT
Example:
FAULT 200 ;Sets fault #200
V0=200
FAULT V0
;incorrect. Variables not allowed here
57