Operation – Lenze S94P01G Position Servo User Manual
Page 61
![background image](/manuals/566072/61/background.png)
S94P01G
59
Operation
Gain Scaling set OK
Motor Velocity resembles Commanded
Velocity. Motor Velocity is reasonably close
with a slight overshoot.
Gain Scaling set too HIGH
Motor Velocity shows significant overshoot
following the acceleration periods.
Gain Scaling set significantly too HIGH
Motor Velocity exhibits instability throughout
the steady state Commanded Velocity.
Depending on the system begin tuned, the motor may go from stable operation (little to
no overshoot with stable steady state velocity) to instability (continuous and pronounced
oscillations during steady state command) very quickly as gains scaling is increased.
The bandwidth for allowing some overshoot with a quick settle time may be very small
and may only be achieved through adjustment of the Velocity P-Gain, as described in
Step 2. Set the gain scaling parameter to the value preceding that where significant
overshoot or continuous instability occurs. With the Gain scaling parameter set move
onto tuning the velocity P and I gains.