Lenze S94P01G Position Servo - Manual (Page 9)

S94P01G
7
Introduction
Liability • The information, data, and notes in these instructions met the state of the art at the time
of publication. Claims on modifications referring to controllers that have already been
supplied cannot be derived from the information, illustrations, and descriptions.
• The specifications, processes and circuitry described in these instructions are for guidance
only and must be adapted to your own specific application. Lenze does not take
responsibility for the suitability of the process and circuit proposals.
• The specifications in these Instructions describe the product features without guaranteeing
them.
• Lenze does not accept any liability for damage and operating interference caused by:
- Disregarding the operating instructions
- Unauthorized modifications to the controller
- Operating errors
- Improper working on and with the controller
Warranty • Warranty conditions: see Sales and Delivery Conditions of Lenze Drive Systems GmbH.
• Warranty claims must be made to Lenze immediately after detecting the deficiency or fault.
• The warranty is void in all cases where liability claims cannot be made.
Disposal Material Recycle Dispose
Metal • -
Plastic • -
Assembled PCB’s - •
1.4 Part Number Designation
The table herein describes the part number designation for the PositionServo drive. The
available filter and communication options are detailed in separate tables.
E94 P 020 S 1 N E X
Electrical Products in the 94 Series
P = PositionServo Model 940 with Encoder Feedback
R = PositionServo Model 941 with Resolver Feedback
Drive Rating in Amps:
020 = 2 Amps 090 = 9 Amps
040 = 4 Amps 100 = 10 Amps
050 = 5 Amps 120 = 12 Amps
060 = 6 Amps 180 = 18 Amps
080 = 8 Amps
Input Phase:
S = Single Phase Input only
Y = Single or Three Phase Input
T = Three Phase Input only
Input Voltage:
1 = 120 VAC Doubler (120V, 1~ in/ 240V, 3~ out)
2 = 200/240 VAC
4 = 400/480 VAC
Line Filter
N = No Line Filter
F = Integrated Line Filter
Secondary Feedback
E = Incremental Encoder
R = Standard Resolver
EN954-1 Safety Circuit
X = No EN954 Safety Circuit