Lenze S94P01G Position Servo - Manual (Page 76)

S94P01G
74
Diagnostics
8.2 LEDs
The PositionServo has five diagnostic LEDs located around the periphery of the front
panel display as shown in the drawing below. These LEDs are designed to help monitor
system status and activity as well as troubleshoot any faults.
S913
LED Function Description
A Enable Orange LED indicates that the drive is ENABLED (running).
B Regen Yellow LED indicates the drive is in regeneration mode.
C Data Entry Yellow LED will flash when changing.
D Comm Fault Red LED illuminates upon a communication fault. (in CANbus only)
E Comm Activity Green LED flashes to indicate communication activity.
8.3 Faults
8.3.1 Fault Codes
Listen herein are fault codes caused mostly by hardware operations. Refer to the
PositionServo Programming Manual for additional fault codes related to programming.
Fault
Code
(Display) Fault Description
F_OU Over voltage
Drive bus voltage reached the maximum level, typically due to motor
regeneration
F_FB Feedback error
Invalid Hall sensors code; Resolver signal lost or at least one motor hall
sensor is inoperable or not connected.
F_OC Over current
Drive exceeded peak current limit. Software incapable of regulating current
within 15% for more than 20mS. Usually results in wrong motor data or
poor tuning.
F_Ot Over temperature
Drive heatsink temperature has reached maximum rating.
Trip Point = 100°C for all drives except 480V 6A & 9A drives
Trip Point = 108°C for 480V 6A & 9A drives
F_OS Over speed Motor has reached velocity above its specified limit
F_PE
Position Error
Excess
Position error has exceeded maximum value.
F_bd Bad motor data Motor profile data is invalid or no motor is selected.
F_EP EPM failure EPM failure on power up
-EP- EPM missing EPM not recognized (connected) on power up
F_09
Motor over
temperature
Motor over temperature switch activated; Optional motor temperature
sensor (PTC) indicates that the motor windings have reached maximum
temperature
F_10
Subprocessor
failure
Error in data exchange between processors. Usually occurs when EMI
level is high due to poor shielding and grounding.
F_14 Under voltage
Occurs when the bus voltage level drops below 50% of nominal bus
voltage while drive is operating. An attempt to enable the drive with low bus
voltage will also result in this fault