Lenze E94P PositionServo Modbus - Manual (Page 8)

8 P94MOD01C
Introduction
2.3 Ethernet Port
• Supported baudrates: 100Mbps and 10Mbps
• Supports two simultaneous Modbus TCP/IP connections on port 502
• Complies with IEEE 802.3
• Standard screened RJ45 connector with integrated status LEDs
• On open connections with no activity for more then 75 seconds, the PositionServo Drive sends a TCP keep-
alive message every 75 seconds to check the connection status.
NOTE:
The PositionServo does not support auto negotiation/cross over. Therefore, unless the connecting
device supports auto negotiation/cross over, a crossover cable will be required for one-to-one
connection.