Lenze E94ARNE Regenerative power supply - Manual (Page 55)

EDS94ARNExxxx EN 2.3 - 06/2014
L
55
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1.15 Inhibit controller
With the device command C00002 = "41: Inhibit controller", the power output stages in
the regenerative power supply module can be inhibited for power recovery. The supply to
the DC bus is not affected by this "controller inhibit".
 The controller can also be inhibited by other sources, e.g. via the digital input RFR or by
the application.
 The sources or trip elements that are active for controller inhibit are displayed in a bit-
coded manner in C00158 .

Tip!
This device command can also be activated via the icon in the Toolbar.
Related device commands
 Enable controller
( 56)

Note!
This device command has no status display in C00003 , i.e. the display remains
unchanged showing the previous device command status.