Lenze E94ARNE Regenerative power supply - Manual (Page 78)

9400 regenerative power supply module | Parameter setting
Device interface
Device commands
78
L
EDS94ARNExxxx EN 2.3 - 06/2014
4.1.36 Restart controller
The device command C00002 = "11000: Restart controller" serves to restart the
regenerative power supply module by parameter setting.
 Only possible when the controller is inhibited and the application has been stopped.
Possible status displays for this device command
Status ( C00003 ) Meaning
720930050 Device command in process
720896001 General fault

Note!
Because of the restart in the case of a successful execution of the device
command, this status will not be displayed in C00003 .
If this device command is used, the "Undervoltage in DC bus (0x007b000f)"
message may appear in the logbook.