MK Diamond MK-770 - Manual (Page 14)

MK-770 Revision 06/05, Effective Date June 17, 2005 Page 14
UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
(D)
Place the Shaft Wrench
between the Inner Blade Guard
and the Motor and onto the
Motor Shaft
(I)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct
(J)
Tighten the Blade Guard
Retaining, Wing nut
Rotation Direction
(G)
Install the Retaining Nut and
Outer Flange and then tighten
using the Blade and Shaft
Wrenches
(K)
Tighten the Blade Guard,
Retaining Knob
(E)
Using the Blade and Shaft
Wrenches, loosen and remove
the Retaining Nut and Outer
Flange
Inner Blade
Guard
Motor
Shaft
Wrench
Motor Shaft
(H)
Close the Blade Guard
Rotate counter-
clockwise to close
Blade
Guard
Retaining nut and
Outer Flange
Shaft
Wrench
Blade
Wrench
Turn counter-
clockwise to
loosen
(F)
Install Diamond Blade
onto Blade Shaft
Diamond
Blade
Blade
Shaft
Retaining nut and
Outer Flange
Shaft
Wrench
Blade
Wrench
Turn clockwise
to tighten
Blade Guard
Retaining Wingnut
Rotate clockwise
to tighten
Blade Guard
Retaining Knob
Rotate clockwise
to tighten