MK Diamond MK-770 - Manual (Page 22)

MK-770 Revision 06/05, Effective Date June 17, 2005 Page 22
SETUP, ADJUSTMENT and OPERATION
3. Diagonal Cutting:
NOTE: To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134557-MK) should be used.
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.
NOTE: If Cutting the tile in two equal halves, align the tile in the V-notch of the Movable Cutting Table
Ruler/Stop.
On Position
(A)
Remove the Adjustable Cutting
Guide
(B)
Place the Dual 45º Flat Angle
Guide on the Ruler/Stop
(C)
Position the Dual 45º Flat
Angle Guide and tighten the
retaining thumbscrew
(D)
Position the tile against the
Dual 45º Flat Angle Guide and
the Ruler/Stop
(G)
Perform the cut
Ruler/Stop
Turn counter-
clockwise to loosen
Align Guide
to Ruler/Stop
Turn Clockwise
to tighten
45º Flat
Angle Guide
Ruler/Stop
Hold Work
in Position
Direction
of Cut
Turn counter-
clockwise to loosen
Adjustable
Cutting Guide
Ruler/Stop
(E)
Turn the motor ON
(H)
Turn the motor OFF when work
is complete
(F)
Verify cooling flow on both sides
of the blade (See Maintenance
Section to adjust flow)
ON/OFF
Switch
Cooling Flow
Points
ON/OFF
Switch
Off Position
Shown