MK Diamond MK-770 - Manual (Page 19)

MK-770 Revision 06/05, Effective Date June 17, 2005 Page 19
SETUP, ADJUSTMENT and OPERATION
ADJUSTMENT and OPERATION:
1. Cutting Straight Edges:
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was
designed.
(A)
Loosen the Adjustable Cutting
Guide retaining thumbscrew
(B)
Position the Adjustable Cutting
Guide to desired cut length
indicated inside the diamond
(C)
Tighten the retaining
thumbscrew
(D)
Place the tile against the
Ruler/Stop and Cutting Guide
(E)
Turn the motor ON
(F)
Verify cooling flow on both sides
of the blade (See Maintenance
Section to adjust flow)
(G)
Perform the cut
(H)
Turn the motor OFF when work
is complete
Desired cut length
indicated here
Turn clockwise
to tighten
Ruler/Stop
Hold Work
in Position
Direction
of Cut
Turn counter-
clockwise to loosen
ON/OFF
Switch
Cooling Flow
Points
Adjustable
Cutting Guide
Off Position
Shown
On Position
ON/OFF
Switch