MK Diamond MK-770 - Manual (Page 23)

MK-770 Revision 06/05, Effective Date June 17, 2005 Page 23
SETUP, ADJUSTMENT and OPERATION
4. Off-angle Cutting:
NOTE: To cut angles other than 45º angles, a Protractor (MK Diamond Part No. 134569-MK) should be used.
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.
(G)
Position the tile against the
Protractor and the Ruler/Stop
(F)
Tighten the retaining
thumbscrew
(B)
Place the Protractor on the
Ruler/Stop
(C)
Set the desired angle on the
Protractor Gage
(J)
Perform the cut
Turn counter-
clockwise to loosen
Align Guide
to Ruler/Stop
Ruler/Stop Set Angle
Ruler/Stop
Hold Work
in Position
Direction
of Cut
(A)
Remove the Adjustable Cutting
Guide
Turn counter-
clockwise to loosen
Adjustable
Cutting Guide
Ruler/Stop
(E)
Position the Protractor Cutting
Guide to the desired cut length
indicated inside the diamond
Desired Cut length
indicated here
Turn Clockwise
to tighten
Protractor
(H)
Turn the motor ON
(I)
Verify cooling flow on both sides
of the blade (See Maintenance
Section to adjust flow)
(K)
Turn the motor OFF when work
is complete
ON/OFF
Switch
Cooling Flow
Points
(D)
Tighten the Protractor Gage
retaining thumbscrew
Turn Clockwise
to tighten
On Position
Off Position
ON/OFF
Switch