MK Diamond MK-770 - Manual (Page 30)

MK-770 Revision 06/05, Effective Date June 17, 2005 Page 30
MAINTENANCE AND TROUBLESHOOTING
5. Diamond Blade Change-out:
NOTE: When installing the Retaining Screw, do not “cross-thread" and DO NOT over tighten the screw.
(F)
Verify the Blade is seated on
the Blade Shaft and direction of
rotation is correct
Rotation Direction
(D)
Install the Diamond Blade onto
Blade Shaft
(B)
Remove Retaining Nut and
Outer Flange
(A)
Open the Outer Blade
(C)
Remove Diamond Blade from
Blade Shaft
Blade
Guard
Retaining nut and
Outer Flange
Shaft
Wrench
Turn counter-
clockwise to
loosen
Blade
Wrench
Diamond
Blade
Blade
Shaft
Diamond
Blade
Blade
Shaft
(E)
Install the Retaining Nut and
Outer Flange and then tighten
using the Blade and Shaft
Wrenches
Retaining nut and
Outer Flange
Shaft
Wrench
Blade
Wrench
Turn clockwise
to tighten
(A)
Close the Outer Blade
Blade
Guard