MK Diamond MK-145 220 Volt - Manual (Page 12)

MK Diamond Products Inc. Customer Service Department (800) 421-5830
MK-145 Revision 09/04, Effective date – September 23, 2004 Page 12
UNPACKING, TRANSPORT and ASSEMBLY:
UNPACKING:
Your MK-145 has been shipped from the factory thoroughly inspected. Only minimal
assembly is required.
If not done, remove the MK-145 from the box and place on a flat surface.
Remove the Water Basin, Cover (See Step 1 of the Blade Guard Installation Procedure;
page 13.), and remove the accessories package from the Water Basin.
CONTENTS:
In your container, you will find one (1) MK-145, one (1) 4-1/2 inch diamond blade, one (1)
metal inner flange, one (1) plastic outer flange, one (1) blade nut, (1) 45º cutting guide one,
(1) adjustable cutting guide, two (2), adjustable cutting guide retaining knobs, one (1)
adjustable blade guard, one (1) blade guard retaining screw, one (1) MK-145 table stop,
one (1) blade wrench, one (1) owners manual, and one (1) warranty card
MK-145 Diamond Blade Metal
Inner Flange
Plastic
Outer Flange
Blade
Nut
45º Cutting
Guide
Adjustable
Cutting Guide
Adjustable
Cutting Guide
Knobs
Blade
Guard
Blade Guard
Retaining Screw
MK-145
Table Stop
Blade
Wrench
Owners
Manual
Warranty
Card
TRANSPORT:
The MK-145 weighs approximately eleven (11) pounds, making transport easy.
Never transport the MK-145 with water in the Cooling Basin.
The MK-145 is designed with recessed edges in the molded plastic case for ease of
transport. To transport the MK-145, simply grasp it by the two recessed edges, lift and
move it to the desired location.