MK Diamond MK-145 220 Volt - Manual (Page 26)

MK Diamond Products Inc. Customer Service Department (800) 421-5830
MK-145 Revision 09/04, Effective date – September 23, 2004 Page 26
MAINTENANCE and TROUBLESHOOTING:
Blade Will Not Cut Properly:
STEP ACTION
1 Check Blade for Smoothness ("Glazing")
•
If blade is smooth, sharpen per Blade
Sharpening Section of this manual
•
If blade is not glazed, go to step 2
2. Check Blade Rotation
Verify blade rotates in counter-clockwise direction
as indicated by arrow on the diamond blade.
• If not rotating correctly, reposition the blade to
correct position
• If rotating correctly, go to step 3
3. Ensure Blade Core Not Bent
• If the blade core is bent, replace blade per the
Diamond Blade Change-out procedure of this
manual
• If the blade core is not bent, go to step 4
4. Check Blade is Correct for Material Being Cut
Contacting place of purchase or MK Diamond at –
800-421-5830 to verify blade
• If the blade is not correct, obtain the correct
blade
• If the blade is correct, go to step 5
5. Return the MK-145 for Repair
• Return the MK-145 for repair per the Return
Instructions section of this procedure
Check for
Glazing
Check for Bent
or Damaged Core
Check Correct
Blade is Being
Used
Return to
MK Diamond
for Repair
Check for
Correct Rotation