MK Diamond MK-145 220 Volt - Manual (Page 19)

MK Diamond Products Inc. Customer Service Department (800) 421-5830
MK-145 Revision 09/04, Effective date – September 23, 2004 Page 19
SETUP, ADJUSTMENT and OPERATION:
Diagonal Cutting:
STEP ACTION
1. Setup Diagonal Cutting Guide
a) Place the Diagonal Cutting Guide against the
Adjustable Cutting Guide
b) Fit the tile into the retaining slot of the Diagonal
Cutting Guide
2. Position Adjustable Cutting Guide
c) Loosen the two (2) Retaining Knobs
d) Align the Adjustable Cutting Guide to the
desired cut position
c) Retighten the Retaining Knobs
3. Set the Blade Guard
a) Set Blade Guard above the top of the
Tile
4 Turn on the MK-145
a) Turn on the MK-145
b) Verify Cooling Water Flow around Blade Guard
DO NOT FORCE TOOL, it will do the job better and safer at the rate for
which it was designed.
5. Cutting Tile
a) Feed the tile into the Diamond Blade with a
steady even pressure (forcing the tile will cause
the blade to slow which could cause motor
overheating)
6. Cutting Complete
a) Turn saw off when cutting is complete
Switch ON
Diagonal Cutting
Guide Placement
Position Tile
for Cut
Blade Guard Set
Feed Tile Slowly
Off Position
Tile Placement