MK Diamond MK-145 220 Volt - Manual (Page 20)

MK Diamond Products Inc. Customer Service Department (800) 421-5830
MK-145 Revision 09/04, Effective date – September 23, 2004 Page 20
SETUP, ADJUSTMENT and OPERATION:
Cutting 22.5 and 45 Degree Angles:
STEP ACTION
1. Cover Stay
a) Pull out the two (2) Cover Stays located on the
bottom of the Water Basin Cover
2. 22.5-Degree Angles
a) Place the Cover Stays into the two (2) 22.5-
degree Angle Slots (lower slots) located inside
the Water Basin
3. 45-Degree Angles
a) Place the Cover Stays into the two (2) 45-
degree Angle Slots (upper slots) located inside
the Water Basin
NOTE: Placing the Adjustable Cutting Guide against the edge of the tile will provide
added support during the cut, and, will reduce the chance of being injured by
sharp edges and chips.
4. Placing the Tile
a) Place the tile onto the raised Cutting Table with
the glazed side down
b) Verify the tile is resting against the Tile Support
Groove of the Cutting table
5. Position Adjustable Cutting Guide
a) Loosen the two (2) Retaining Knobs
b) Position the Adjustable Cutting Guide against
the edge of the tile
a) Retighten the Retaining Knobs
6. Set the Blade Guard
a) Set Blade Guard above the top of the tile
7. Turn on the MK-145
c) Turn on the MK-145
d) Verify Cooling Water Flow around Blade Guard
Cover Stay
22.5º Angle Position
45º Angle Position
Tile Support Groove
Tile Placement
On Position
Position Adjustable
Cutting Guide
Set Blade Guard