MK Diamond MK-145 220 Volt - Manual (Page 14)

MK Diamond Products Inc. Customer Service Department (800) 421-5830
MK-145 Revision 09/04, Effective date – September 23, 2004 Page 14
UNPACKING, TRANSPORT and ASSEMBLY:
STEP ACTION
5. Install Plastic Outer Flange
a) Install the Plastic Outer Flange onto the Gear
Shaft
NOTE: Do not “cross-thread the Retaining Nut during installation.
6. Install The Retaining Nut
a) Install the Retaining Nut onto the Gear Shaft –
DO NOT CROSS-THREAD THE NUT
7. Tightening Diamond Blade
a) Hold the Diamond Blade still
b) Rotate the Blade Wrench clockwise to tighten –
DO NOT OVER TIGHTEN
8. Reinstall the Water Basin Cover
a) Insert the three (3) Cover Retaining Tabs into
the three (3) Cover Alignment Slots
b) Seat the Water Basin Cover on the MK-145
Adjustable Cutting Guide Installation:
NOTES: 1. The Adjustable Cutting Guide can be used on either side of the Diamond
Blade.
2. Step 1 may be skipped if the Adjustable Cutting Guide is installed.
1. Install the Adjustable Cutting Guide
a) Fit the Retaining Tabs of the Adjustable Cutting
Guide to the Horizontal Grooves of the MK-145
b) Slide the Adjustable Cutting Guide onto the
MK-145
2. Retaining Knobs
a) Install the two Retaining Knobs into either side
of the Adjustable Cutting Guide
Alignment
Slot
Retaining Tab
Retaining Knob
Ruler
Horizontal
Groove
Retaining Tab
Plastic Outer
Flange
Retaining nut
Rotate to
tighten
Blade
Wrench